Military Surplus Radio Tower

P&K 60 foot, tilt-over base, guyed (square pattern)

Specifications:

P&K model AB-175/GR.  No manual but available on the web for $3.00

(7) 10 foot sections, quick connect assembly.

Triangular shape, 1/2" solid steel legs 1/2" diameter on 6-1/2" centers   3/16" "W" bracing. (all galvanized)

Heavy duty aluminum base plate with cast aluminum tilt-over feature.  Includes a second hinged assembly for setting up a raising fixture.  one of the tower sections would be used for this and this is where you would attach the winch (not included).

(4) sets of stainless steel, 3/16" wire rope guy wires.  Includes clamps, turnbuckles, insulators and tension gimmicks.  Being stainless, most of the guy wire is like new but some of  the turnbuckles are a bit rusty.

Photos, click the thumbnail to enlarge.

	Complete package: (7) 10-foot sections, tilt-over base, guys, anchor rods.
	Raising fixture.  object to the right is the top bearing with sleeve for 2" pipe mast
	Closer view of the tilt-over section.  This attaches to the base plate with the pin shown.
	Sections shown inverted with guy plates.
	Guys and guy hardware.  Several hundred feet, not measured.
	This view shows the relative size of the tower sections.  They weigh about 20# each less the hardware.
	Base section mounted on base plate.  The piece behind the tilt-over fixture is used to attach the raising section.  It attaches to the tilt-over fixture.
	Close-up of the tilt-over fixture.

This is not scrap metal.  This is a very usable tower and needs very little work to refurbish.  We want to sell as a package, not in pieces.  Make a reasonable offer.

Contact KG6WKM (gprescott at sbcglobal dot net  or N6XN  (n6xn at arrl dot net)